Here is the contents of the kit, there is a video on line that shows how easy it is to use, comes with full instructions. Also make sure you have a male and female brake pipe end cap handy to seal the brake hose and pipe once it is removed. Support the brake hose end of the fitment with an ordinary spanner to stop it rotating, there is a flat cut into the cylindrical steel ferrule of the brake hose for you to do this (see photo to left).

firstly I told him on the day to go and get some more fluid and top it up before it empties the ABS module - he didn't. At this point, don't feed any more pipe through, but step back from the engine and straighten the rest of the pipe out in front of the car . There are several actions that could trigger this block including submitting a certain word or phrase, a SQL command or malformed data. As has been said, your first issue will be trying to flare the current steel lines if you chose to cut and splice in a piece.Note; Brake lines are a safety critical component and should only be repaired or made by competent persons with sufficient knowledge and experience to complete the work to a safe standard.

However, do not mix and match like this for any part that is going to be left on the car permanently. However, you do risk scoring your brake master cylinder using this method by forcing down further than it would normally go into old dirty deposits. I was going to replace the piece of the line from where its behind the rear wheel liner to the caliper. A lot depends on if you are doing steel, stainless or kunifer - and if you ned to do it on the vehicle or not. Note the position of the types of boy fixings and, if you are replacing a rear brake, note the position of the fixings shown in the photo.If you only need to replace a front brake line then you can get away with just jacking up the front of the car and making the front two wheels accessible. Brake pipe flares are the way in which the end of your brake pipe is "flared" out to joint the next brake fitment, they do not relate to the type of fitment itself. Finally seal the end of the brake pipe with a female brake pipe end cap and make sure you clean up any spilt brake fluid with rags immediately as it is very corrosive.